IR2130

3-PHASE BRIDGE DRIVER

VOFFSET 600V max.

IO+/- 200 mA / 420 mA VOUT 10 – 20V

ton/off (typ.) 675 & 425 ns

Deadtime (typ.) 2.5 µs (IR2130)

0.8 µs (IR2132)

Features

Floating channel designed for bootstrap operation

Fully operational to +600V

Tolerant to negative transient voltage dV/dt immune

Gate drive supply range from 10 to 20V
Undervoltage lockout for all channels
Over-current shutdown turns off all six drivers
Independent half-bridge drivers
Matched propagation delay for all channels
5V logic compatible
Outputs out of phase with inputs
Cross-conduction prevention logic
Also available LEAD-FREE

Description

The IR2130/IR2132(J)(S) is a high voltage, high speed power MOSFET and IGBT driver with three indepen- dent high and low side referenced output channels. Pro- prietary HVIC technology enables ruggedized monolithic construction. Logic inputs are compatible with CMOS or LSTTL outputs, down to 2.5V logic. A ground-referenced operational amplifier provides analog feedback of bridge current via an external cur- rent sense resistor. A current trip function which termi- nates all six outputs is also derived from this resistor. An open drain FAULT signal indicates if an over-cur-

for minimum driver cross-conduction. Propagation delays are matched to simplify use at high frequencies. The floating channels can be used to drive N-channel power MOSFETs or IGBTs in the high side configuration which operate up to 600 volts.

Absolute Maximum Ratings

Absolute Maximum Ratings indicate sustained limits beyond which damage to the device may occur. All voltage param- eters are absolute voltages referenced to VS0. The Thermal Resistance and Power Dissipation ratings are measured under board mounted and still air conditions. Additional information is shown in Figures 50 through 53.

Symbol	Definition		Min.	Max.	Units
VB1,2,3	High Side Floating Supply Voltage		-0.3	625
VS1,2,3	High Side Floating Offset Voltage		VB1,2,3 – 25	VB1,2,3 + 0.3	V
VHO1,2,3	High Side Floating Output Voltage		VS1,2,3 – 0.3	VB1,2,3 + 0.3
VCC	Low Side and Logic Fixed Supply Voltage		-0.3	25
VSS	Logic Ground		VCC – 25	VCC + 0.3
VLO1,2,3	Low Side Output Voltage		-0.3	VCC + 0.3
VIN	Logic Input Voltage ( HIN1,2,3 , LIN1,2,3 & ITRIP)		VSS – 0.3	(VSS + 15) or (VCC + 0.3) whichever is lower
VFLT	FAULT Output Voltage		VSS – 0.3	VCC + 0.3
VCAO	Operational Amplifier Output Voltage		VSS – 0.3	VCC + 0.3
VCA-	Operational Amplifier Inverting Input Voltage		VSS – 0.3	VCC + 0.3
dVS/dt	Allowable Offset Supply Voltage Transient		—	50	V/ns
PD	Package Power Dissipation @ TA £ +25°C	(28 Lead DIP)	—	1.5	W
		(28 Lead SOIC)	—	1.6
		(44 Lead PLCC)	—	2.0
RthJA	Thermal Resistance, Junction to Ambient	(28 Lead DIP)	—	83	°C/W
		(28 Lead SOIC)	—	78
		(44 Lead PLCC)	—	63
TJ	Junction Temperature		—	150	°C
TS	Storage Temperature		-55	150
TL	Lead Temperature (Soldering, 10 seconds)		—	300

Recommended Operating Conditions

The Input/Output logic timing diagram is shown in Figure 1. For proper operation the device should be used within the recommended conditions. All voltage parameters are absolute voltages referenced to VS0. The VS offset rating is tested with all supplies biased at 15V differential. Typical ratings at other bias conditions are shown in Figure 54.

Symbol	Definition	Min.	Max.	Units
VB1,2,3	High Side Floating Supply Voltage	VS1,2,3 + 10	VS1,2,3 + 20	V
VS1,2,3	High Side Floating Offset Voltage	Note 1	600
VHO1,2,3	High Side Floating Output Voltage	VS1,2,3	VB1,2,3
VCC	Low Side and Logic Fixed Supply Voltage	10	20
VSS	Logic Ground	-5	5
VLO1,2,3	Low Side Output Voltage	0	VCC
VIN	Logic Input Voltage (HIN1,2,3 , LIN1,2,3 & ITRIP)	VSS	VSS + 5
VFLT	FAULT Output Voltage	VSS	VCC
VCAO	Operational Amplifier Output Voltage	VSS	VSS + 5
VCA-	Operational Amplifier Inverting Input Voltage	VSS	VSS + 5
TA	Ambient Temperature	-40	125	°C

Note 1: Logic operational for VS of (VS0 – 5V) to (VS0 + 600V). Logic state held for VS of (VS0 – 5V) to (VS0 – VBS). (Please refer to the Design Tip DT97-3 for more details).

Note 2: All input pins, CA- and CAO pins are internally clamped with a 5.2V zener diode.